1. First, measure the length of the PVC board to be installed and cut the length of the aluminum alloy according to the size. Depending on the size of the wall panel, calculate the entire number block required for the wall panel and use the excess wall panel space for the joint.
2. punch the fixing holes on the aluminum alloy, drill the wall according to the distance between the holes on the aluminum alloy p, and fix the rack hook on the wall with expansion screws or steel nails.
3. To fix the upper corner line, usually put special glue on both sides, then paste it on the upper corner, pull it for a few minutes, then paste it firmly. In rooms with high humidity, when two sets of plinths are connected, it is necessary to provide adequate expansion joints, especially in the corners where the furniture is placed.
4. Install the PVC sheet, place the panel in the side line from left to right, and the starting block is torn from corner to corner. Place the expansion screws or steel screws 1.5 cm from the top of the wall plate, being careful not to expose the surface of the wall plate. Apply special glue on the back and place it in the concave and convex surface after a few minutes. The corners must be inclined at 45°.
5. Place the anti-friction rubber band on the aluminum bayonet. Place the left and right panels on both sides of the wall. Cut a length of PVC paper. and close the aluminum alloy panel until the installation is complete
6. Once installed, cover both sides of the chamber with special glue. Put it in the top corner. Then pull away a bit and cry hard. This increases the stiffness of the glasses and increases their service life.
